Profinet Master Programming – Demo

This video shows the step-by-step programming of a Profinet Master. Learn how devices are integrated, connections are configured, and control logic is programmed – all on a standard PC.

Show Full Transcript

Introduction

Welcome to Sybera. In this video, we guide you through the programming of a Profinet Master.

Project Creation

00:00:05

Create a new project in the Profinet Master software and define the network structure.

Device Integration

00:00:25

Integrate the Profinet devices, assign IP addresses, and set the device parameters.

Programming & Configuration

00:00:50

Create the control logic and configure the connections between the Master and the devices.

Test & Validation

00:01:30

Perform a connection test, check the communication, and adjust the programming if necessary.

Saving & Conclusion

00:02:10

Save all project settings. The Profinet Master is now programmed and ready for use.

Conclusion

00:02:30

Thank you for your attention. Visit our website for more tutorials on Profinet Master programming and network commissioning.